Lenze 8400 StateLine - Manual (Page 784)

15 Parameter reference
15.2 Parameter list | C01351
784
Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01351
Parameter | Name:
C01351 | ACDrive: Control word
Data type: UNSIGNED_16
Index: 23224
d
= 5AB8
h
From version 13.00.00
Display of the "AC Drive Profile" control word for the controller
• Detailed information on the "AC Drive Profile" can be found in the EtherNet/IP™ communication manual.
 Actuating drive speed (AC Drive Profile)
Display area (min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded: Info
Bit 0 Run Forward Relationships between Run1 and Run2 and trigger
events can be found in the chapter " Run/Stop Event ".
Bit 1 Run Backward
Bit 2 Fault Reset
0->1 ≡ Reset error
0 ≡ No response
Bit 3 Reserved
Bit 4 Reserved
Bit 5 NetCtrl Run/Stop control:
0 ≡ via local setting in the device or terminal
1 ≡ via fieldbus (e.g. by the scanner)
Bit 6 NetRef Reference speed/reference torque:
0 ≡ via local setting in the device or terminal
1 ≡ via fieldbus (e.g. by the scanner)
Bit 7 Reserved
Bit 8 Reserved
Bit 9 Reserved
Bit 10 Reserved
Bit 11 Reserved
Bit 12 Reserved
Bit 13 Reserved
Bit 14 Reserved
Bit 15 Reserved
Subcodes Info
C01351/1 ACDrive: Control word
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT