Lenze 8400 StateLine - Manual (Page 22)

2 Introduction: Parameterising the controller
2.1 Integrated technology applications
22
Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.1 Integrated technology applications
The following technology applications integrated in the drive controller 8400 StateLine provide the
main signal flow for the implementation of a general or a special drive solution:
Technology application "Actuating drive speed"
This preset technology application serves to solve speed-controlled drive tasks, e.g.
conveyor drives (interconnected), extruders, test benches, vibrators, travelling drives,
presses, machining systems, metering units.
technology application "Actuating drive speed (AC Drive Profile)"
This technology application available
from version 13.00.00 provides a speed and
torque control by means of "AC Drive Profile". The fieldbuses EtherNet/IP™ and
system bus (CANopen) are supported.
"Switch-off positioning" technology application
This technology application available
from version 04.00.00 is used to solve speed-
controlled drive tasks which require a pre-switch off or stopping at certain positions,
e.g. roller conveyors and conveying belts. The pre-switch off is implemented by
connecting switch-off sensors.

Note!
Please note that the "StateLine", "HighLine" and "TopLine" device types differ with regard
to the number, functional range, and flexibility of the technology applications offered.

Detailed information on each technology application can be found in the main chapter
" Technology applications ". ( 296)