Lenze 8400 StateLine - Manual (Page 289)

Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
289
6 I/O terminals
6.4 User-defined terminal assignment
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.4 User-defined terminal assignment
In order to individually adapt the preconfigured assignment of the input/output terminals to your
application, you can choose one of the following procedures:
A. In the »Engineer«:
• Change the terminal assignment on the Terminal assignment tab.
• Change the signal assignment on the Application Parameters tab, on the dialog level
Overview  Signal flow.
• Change the interconnections in the FB editor (on the I/O level).
B. In the »Engineer« or with the keypad:
• Change the parameters for signal configuration in the parameters list.

Tip!
First of all, select a Lenze configuration useful for the purpose at hand by going to
C00005
and selecting a technology application that matches your drive task and then going to
C00007 and selecting an appropriate control mode. You will then have an application for
which there is a signal flow, logical block links and terminal assignment.
We recommend using the »Engineer« for the implementation of comprehensive user-
defined drive solutions.

Note!
If you change the preconfigured assignment of the input/output terminals, the terminal
assignment will be a user-defined one. In C00007 , control mode "0: Interconnection
changed" will be shown.