Lenze 8400 StateLine - Manual (Page 670)

15 Parameter reference
15.2 Parameter list | C00357
670
Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00357
C00358
C00359
Parameter | Name:
C00357 | CAN monitoring times
Data type: UNSIGNED_16
Index: 24218
d
= 5E9A
h
Mapping of the RPDO event time (see DS301 V4.02)
• If a value unequal to "0" is entered, the RPDO is not expected before the set time has expired.
• If the RPDO is not received within the expected time, the response set in C00593/1...4 will be triggered.
 System bus "CAN on board"
Setting range (min. value | unit | max. value)
0 ms 65000
Subcodes Lenze setting Info
C00357/1 3000 ms CAN1_IN monitoring time
C00357/2 3000 ms CAN2_IN monitoring time
C00357/3 3000 ms CAN3_IN monitoring time
C00357/4 3000 ms CAN4_IN monitoring time
• From version 15.00.00
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00358 | CANx_OUT data length
Data type: UNSIGNED_8
Index: 24217
d
= 5E99
h
From version 03.00.00
Setting of the data length for TX PDOs
 System bus "CAN on board"
Setting range (min. value | unit | max. value)
1 8
Subcodes Lenze setting Info
C00358/1 8 CAN1_OUT data length
C00358/2 8 CAN2_OUT data length
C00358/3 8 CAN3_OUT data length
C00358/4 8 CAN4_OUT data length
• From version 15.00.00
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00359 | CAN status
Data type: UNSIGNED_8
Index: 24216
d
= 5E98
h
 System bus "CAN on board"
Selection list (read only)
0 Operational
1 Pre-Operat.
2 Reserved
3 Reserved
4 BootUp
5 Stopped
6 Reserved
7 Reset
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1