Lenze 8400 StateLine - Manual (Page 41)

Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
41
2 Introduction: Parameterising the controller
2.4 Device access protection
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Activate device personalisation
The device personalisation is activated by setting a binding ID.

How to set the binding ID:
1. Enter the desired binding ID in C00505/2 .
• The binding ID must have a length of 4 ... 16 characters.
• The binding ID may consist of any character. However, this is not sensible.
Recommended characters are: lower case letters (a - z), upper case letters (A - Z) and
digits (0 - 9).
2. Execute "Set binding ID" device command C00002/29 = "1: On / start"
• After successful execution, status ON is displayed in C00505/2 .
Deactivate device personalisation/change binding ID
The device personalisation is simply deactivated by deleting the set binding ID. If you want to
change the set binding ID, first delete the set binding ID as well. Then set the new binding ID.

How to delete the binding ID:
1. Enter the set binding ID in C00505/2 .
• If controller and memory module do not have the same binding ID, enter the binding ID
of the memory module to delete the binding ID of both components.
2. Execute "Delete binding ID" device command C00002/30 = "1: On / start"
• After a successful deletion, status OFF is displayed in C00505/2 .
Device commands
Before the following device commands are executed, enter the corresponding binding ID in C00505/2 .
C00002/29 Set binding ID
 Activate device personalisation
0: Off / ready
C00002/30 Delete binding ID
 Deactivate device personalisation/change binding ID
0: Off / ready
Status displays
C00003 Status of the last device command -
C00507/1 Password protection - all communication channels
• Bit coded display of the active protective functions:
-
Bit 0 Only access to user menu
Bit 1 Parameter write protection
Bit 2 Parameter read protection
Bit 3 ... 14 Reserved
Bit 16 Memory module binding on
Parameter Info Lenze setting
Highlighted in grey = display parameter