Lenze 8400 StateLine - Manual (Page 479)

Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
479
10 Oscilloscope function
10.3 Operation
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
10.3.4 Starting recording

Click Start to start recording.
To obtain a maximum sample rate when recording the variable values, the data are first stored in
the measured data memory of the 8400 StateLine and then transferred as a data set to the
Engineering PC. The current recording status is displayed in the status bar.
10.3.5 Adjusting the representation
After the variable values have been recorded and the online data set has been transferred to the
Engineering PC, the data set is visualised in the oscillogram. If required, the representation can now
be adjusted by using the zoom or the automatic scaling function.

Tip!
When the oscillogram does not show the complete measurement, a scrollbar appears
below the time axis. You can use this scrollbar for horizontal scrolling of the visible area.
The labelling of the time axis and the position display are automatically adapted.

Note!
Recording can only be started when an online connection has been established to the
8400 StateLine.