Lenze 8400 StateLine - Manual (Page 476)

10 Oscilloscope function
10.3 Operation
476
Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
10.3 Operation
This chapter describes step-by-step how to record the signal characteristics of 8400 StateLine
variables and represent, analyse, document and process them in the oscilloscope.
10.3.1 Selecting the variables to be recorded
The oscilloscope supports up to four channels, i.e. max. four variables can be recorded in a data set.
The variables to be recorded can be configured by means of the Vertical channel settings list field.
Four variables have already been selected in the default setting. In case of the 8400 StateLine, all
available channels are already assigned:

Note!
The oscilloscope can only be configured and recording can only be started when an
online connection has been established to the 8400 StateLine.
Column Name Meaning
1 - Curve colour for representation in the oscillogram
2 Ch Channel number
3 On On/off
4 Inv On/off inversion
5 Name Selection of the variable to be recorded
6 Unit Scaling
7 1/Div Vertical scaling factor
8 Offset Offset value
• The offset value depends on the scaling factor. It is indicated by a dashed
line in the colour of the curve on the left-hand edge of the oscillogram.
9 Position Position value
• The position value is independent of the scaling factor. It is indicated by a
line on the left-hand edge of the oscillogram.