Allied Telesis AT-UWC Series - Manual (Page 75)

Chapter 2: System
75
Trap Receiver Configuration
From the SNMP Trap Receiver Configuration page, you can view a list of
SNMP trap receivers on the WLAN Controller. You can also add, delete, or
modify a trap receiver.
To add, delete, or modify a trap receiver, do the following:
1. From the Navigation pane, go to System > SNMP > Trap Receiver
Configuration.
The SNMP Trap Receiver Configuration page is displayed as shown in
Figure 44.
Figure 44. SNMP Trap Receiver Configuration Page
2. Select an item from the SNMP Trap Name select list:
 Create - Adds a field to specify the SNMP Trap Name.
 SNMP_Trap_name - Displays the settings of the SNMP trap
receiver.
3. Specify the following fields in Table 14.
. Table 14. SNMP Trap Receiver Configuration
Field Description
SNMP Trap
Name Specifies the name of the SNMP trap receiver. You
can specify the name using up to 16 alphanumeric
characters.
SNMP Version Specifies the version of the SNMP. The options are:
 SNMP v1
 SNMP v2c