Allied Telesis AT-UWC Series - Manual (Page 260)

AT-UWC WLAN Controller Web GUI User’s Guide
260
4. Click the following buttons as needed:
 Disassociate — Disconnect the AP client from the access point.
 Refresh — Refreshes the display on this page.
Viewing the
Status of
Neighbor APs
To view the information about neighbor access points that the AP client
can roam, do the following:
1. From the Navigation pane, go to WLAN > Status/Statistics >
Associated Client and click the Neighbor APs subtab.
2. Select the MAC address of the AP client from the select list.
The Associated Client Status Neighbor APs page is displayed.
3. Observe the fields described in Table 100.
VLAN Displays the VLAN ID that is assigned to the AP
client if the AP client is associated with the VAP in
the VLAN forwarding mode.
Transmit Data
Rate Displays the transmit data rate of the AP client.
Network Time Displays the time that has passed since the AP
client was authenticated.
Detected IP
Address Displays the IP address of the AP client if available.
Captive Portal Displays the link to the Captive Portal Client Status
page if the AP client is authenticated via Captive
Portal. See “Client Connection Status” on
page 167.
Table 99. Associated Client Status Detail (Continued)
Field Description
Table 100. Associated Client Status Neighbor APs
Field Description
AP MAC
Address Displays the MAC address of the home access
point of the AP client.
Location Displays the location information of the access
point, which is set in the AP profile.
Radio Displays the radio band of the access point that the
AP client is associated with.