Allied Telesis AT-UWC Series - Manual (Page 289)

Chapter 5: Wireless LAN
289
4. Click the following buttons as needed:
 Acknowledge All Rogues — Clears the classification of all the
rogue AP clients.
 Refresh — Refreshes the display on this page.
Viewing Rogue
Classification
To view a list of tests that classified failed AP clients as rogue, do the
following:
1. From the Navigation pane, go to WLAN > Intrusion Detection >
Detected Clients.
The Detected Client Status page is displayed as shown in Figure 143
on page 284.
2. Click a MAC address from the AP client on the list.
The Detected Client Status Detail page is displayed as shown in Figure
144 on page 286.
3. Click the Rogue Classification tab.
The Rogue Classification page is displayed as shown in Figure 145.
Figure 145. Rogue Classification Page
4. Observe the fields described in Table 120 on page 290.
Treat Mitigation
Sent Displays whether the mitigation is implemented or
not.
Table 119. Detected Client Status Detail (Continued)
Field Description