Allied Telesis AT-UWC Series - Manual (Page 297)

Chapter 5: Wireless LAN
297
AP Authentication Failure
From the AP Authentication Failure page, you can view a list of access
points that failed to connect to the WLAN Controller. You can also add
failed access points to the Valid AP list.
Viewing Failed
Access Points and
Adding Them to
Valid AP List
To view failed access points and add them to the valid AP list, do the
following:
1. From the Navigation pane, go to WLAN > Intrusion Detection > AP
Authentication Failures.
The Access Point Authentication Failure Status page is displayed as
shown in Figure 148.
Figure 148. Access Point Authentication Failure Status Page
2. Observe the fields described in Table 125.
Table 125. Access Point Authentication Failure Status
Field Description
MAC Address Displays the MAC address of the access point.
The asterisk following the MAC address
indicates that the peer controller reported the
failure.
IP Address Displays the IP address of the access point.