Allied Telesis AT-UWC Series - Manual (Page 351)

Chapter 5: Wireless LAN
351
WIDS AP Configuration
From the Wireless Intrusion Detection System (WIDS) AP Configuration
page, you can enable or disable each WIDS feature on access points and
specify the properties.
To enable or disable WIDS and specify the properties, do the following:
1. From the Navigation pane, go to WLAN > Advanced Configuration >
WIDS Security.
The WIDS AP Configuration page is displayed as shown in Figure 168.
Figure 168. WIDS AP Configuration Page
2. Enable or disable each WIDS feature and specify the fields described
in Table 145.
Table 145. WIDS AP Configuration
Field Description
Administrator
configured rogue
AP Displays whether the feature of detecting an
access point on the Valid AP list and marking the
access point as rogue is enabled or disabled.