Allied Telesis AT-UWC Series - Manual (Page 74)

AT-UWC WLAN Controller Web GUI User’s Guide
74
3. Click Submit.
The change is saved to the running configuration file.
Note
To save your changes to the startup configuration file, see “Save All
Applied Changes” on page 39.
Deleting a
Community
String
To delete a community string, do the following:
1. From the Navigation pane, go to System > SNMP > Community
Configuration.
The SNMP Community Configuration page is displayed as shown in
Figure 43 on page 73.
2. Select a community string from the Community select list:
3. Click Delete.
The selected community is deleted.
Note
To save your changes to the startup configuration file, see “Save All
Applied Changes” on page 39.
SNMP Agent
IP address Specifies the IPv4 address of the SNMP agent.
SNMP Agent
IP Mask Specifies the subnet mask of the SNMP agent.
Access Mode Specifies the access modes of the community string.
The options are:
 Read-Only
 Read-Write
Status Specifies the status of the community string. The
options are:
 Enable
 Disable
Table 13. SNMP Community Configuration (Continued)
Field Description