Allied Telesis AT-UWC Series - Manual (Page 277)

Chapter 5: Wireless LAN
277
3. Check the checkbox of the MAC address of access point to manage or
clear the rogue status.
4. Click the following buttons as needed:
 Delete ALL — Deletes all the access point entires from the RF
scan list.
 Manage — Makes the WLAN Controller manage the selected
rogue access points, add to the Valid AP list, and apply the default
AP profile next time the WLAN Controller detect them.
 Acknowledge — Clears the classification of the selected rogue
access points.
 Acknowledge All Rogues — Clears the classification of all the
rogue access points.
 Refresh — Refreshes the display on this page.
Viewing an
Access Point
Detected by RF
Scan
To view the detailed information about the access point detected by RF
scan, do the following:
1. From the Navigation pane, go to WLAN > Intrusion Detection >
Rogue/RF Scan.
SSID Displays the SSID in the beacon frames from the
access point.
Physical Mode Displays the mode of IEEE 802.11 that the access
point uses.
Channel Displays the channel that the access point is using
to communicates.
Status Displays the status of the access point. The options
are:
 Managed - An access point managed by
the WLAN Controller
 Standalone - An access point on the Valid
AP list of the WLAN Controller
 Rogue - An access point classified as an
threat by WIDS
 Unknown - An access point classified not
as an intruder by WIDS
Age Displays the time period since the access point was
detected by RF Scan.
Table 114. Access Point RF Scan Status (Continued)
Field Description