Allied Telesis AT-UWC Series - Manual (Page 329)

Chapter 5: Wireless LAN
329
4. Click the following buttons:
 Refresh — Refreshes the display on this page.
 Clear — Clears the changes you made before clicking Submit.
Table 138. Access Point Profile Global Configuration
Field Description
Profile Name Specifies the name of the AP profile.
Hardware Type ID Specifies the model of the access point that the
profile is applied to. The options are:
 0 - Any - Either AT-TQ3600 or AT-TQ2450
 5 - AT-TQ3600
 9 - AT-TQ2450
Disconnected AP
Data Forwarding
Mode Specifies how the access point behaves when
disconnected from the WLAN Controller. The
options are:
 Enable - The access point operates as a
standalone based on the information
provided by the WLAN Controller.
 Disable - The access point stops sending
receiving messages and changes to the
wait state.
Disconnected AP
Management
Mode Specifies whether access from SNMP is enabled or
disabled when the access point is disconnected
and operates as a standalone. The options are:
 Enable - Enables the management of the
access point by SNMP.
 Disable - Disables the management of the
access point by SNMP.
Wired Network
Discovery VLAN
ID Specifies the VLAN ID that the WLAN Controller
uses to send tracer packets. Tracer packets are
sent to detect the access points that are connected
to the Ethernet.
AP Syslog Mode Specifies whether Syslog is enabled or disabled on
the managed access points.The options are:
 Enable - The access point sends log
messages to the remote host.
 Disable - The access point does not send
log messages to the remote host.