Allied Telesis AT-UWC Series - Manual (Page 194)

AT-UWC WLAN Controller Web GUI User’s Guide
194
WLAN Basic Setup > Discovery
To manage access points, the WLAN Controller discovers access points
or access points discover the WLAN Controller.
Note
To configure access points to be discovered, see the documents for
the access points.
The WLAN Controller discovers access points by sending discovery
packets to a list of the IP addresses and/or sending broadcast discovery
frames to VLAN’s. In addition to access points, the WLAN Controller
discovers peer controllers with the same discovery messages.
From the Wireless Discovery Configuration page, you can configure two
methods for the WLAN Controller to discover access points:
 Layer 3: IP address
 Layer 2: VLAN
Discovery by L3
IP Discovery
To enable the L3/IP discovery, view a list of the IP addresses, add the IP
address of an access point, or delete it, do the following:
1. From the Navigation pane, go to WLAN > Basic Setup and click the
Discovery tab.
The Wireless Discovery Configuration page is displayed as shown in
Figure 103.
Figure 103. Wireless Discovery Configuration Page
2. Specify the following fields described in Table 67 on page 195.