Allied Telesis AT-UWC Series - Manual (Page 217)

Chapter 5: Wireless LAN
217
4. Click the following buttons as needed:
 Cancel — Cancels the changes.
 Apply — Applies the changes.
Changing the
Channel or
Power
To change the channel or power level of the access point, do the following:
1. From the Navigation pane, go to WLAN > AP Management >
Advanced Settings.
The Managed AP Advanced Settings page is displayed as shown in
Figure 113 on page 215.
2. Click the value in the Channel or Power column for the access point
that you want to change its value.
The Managed AP Channel/Power Adjust page is displayed as shown
in Figure 115 on page 218.
Status Displays the debug status.
The options are:
 None - No setting.
 Set Requested - The request of changing the
debug status is made.
 Set Complete - The process of enabling or
disabling the debug status is completed.
Password Enter the password for logging in to the Web console
of the access point. The default password is “friend.”
Confirm
Password Re-enter the password.
Enable Debug Check the checkbox to enable the debugging.
Table 78. Managed AP Debug (Continued)
Field Description