Allied Telesis AT-UWC Series - Manual (Page 298)

AT-UWC WLAN Controller Web GUI User’s Guide
298
3. Click the following buttons as needed:
 Delete All — Clears all the entries from the list.
 Manage — Adds the selected access points to the Valid AP
database.
 Refresh — Refreshes the display on this page.
Viewing Detailed
Information
about Failed
Access Points
To view the detailed information about an access point that failed to
connected to the WLAN Controller, do the following:
1. From the Navigation pane, go to WLAN > Intrusion Detection > AP
Authentication Failures.
The Access Point Authentication Failure Status page is displayed as
shown in Figure 148 on page 297.
2. Click the MAC address of the access point that you want to view the
detail information.
The Access Point Authentication Failure Status Detail page is
displayed as shown in Figure 149 on page 299.
Last Failure type Displays the type of connection failure. The
options are:
 Local Authentication
 No Database Entry
 Not Managed
 Profile Mismatch-Hardware Type
Age Displays the time period since the access point
failed to connect.
Table 125. Access Point Authentication Failure Status (Continued)
Field Description