Allied Telesis AT-UWC Series - Manual (Page 131)

Chapter 3: Switching
131
VLAN Port Configuration
From the VLAN Port Configuration page, you can modify the properties of
the port interface.
Note
The WLAN Controller has only one port interface that you can
modify its properties.
To modify the port interface 0/1, do the following:
1. From the Navigation pane, go to Switching > VLAN > Port
Configuration.
The VLAN Port Configuration page is displayed as shown in Figure 75.
Figure 75. VLAN Port Configuration Page
2. Specify the fields described in Table 36.
Table 36. VLAN Port Configuration
Fields Description
Interface Select “0/1.” The other option is not supported.
Port VLAN ID Specify a VLAN ID. The port applies this VLAN ID to
untagged frames and frames with a priority tag. The
default setting is VLAN ID 1.