Allied Telesis AT-UWC Series - Manual (Page 305)

Chapter 5: Wireless LAN
305
WLAN Advanced Configuration > SNMP Traps
From the Wireless SNMP Trap Configuration page, you can enable and
disable sending traps to SNMP servers.
Note
The WLAN Controller sends traps based on its own events and the
events learned from the access points that the WLAN Controller
manages. The access points do not send traps to SNMP servers.
To enable and disable SNMP traps, do the following:
1. From the Navigation pane, go to WLAN > Advanced Configuration >
Global and click the SNMP Traps tab.
The Wireless SNMP Trap Configuration page is displayed as shown in
Figure 151.
Figure 151. Wireless SNMP Trap Configuration Page
2. Enable or disable the SNMP traps described in Table 129.
Table 129. Wireless SNMP Trap Configuration
Field Description
AP Failure Traps Enable or disable sending AP Failure traps. When it
is enabled, the WLAN Controller sends a trap in the
event of an error when the WLAN Controller
authenticates or connects to the access point.