Allied Telesis AT-UWC Series - Manual (Page 205)

Chapter 5: Wireless LAN
205
RF Management > Configuration
From the RF Configuration page, you can view and modify the RF settings
on managed access points.
Guidelines for the
Channel Plan
Algorithm
The WLAN Controller has the channel plan algorithm that evaluates
interference of the channels used by the access points and changes the
channels when interference is detected.
Here are guidelines for running the channel plan algorithm:
 The WLAN Controller automatically runs the channel plan
algorithm on managed access points when Channel Plan Mode is
selected Fixed Time or Interval.
 The WLAN Controller does not run the channel plan algorithm on
the access point if the channel is manually assigned to the access
point. See “Changing the Channel or Power” on page 217.
 The WLAN Controller does not run the channel plan algorithm on
the access point when Automatic Channel is disabled in the AP
profile that the access point is applied to. See “Access Point Profile
Radio Configuration” on page 331.
To view and modify the RF settings, do the following:
1. From the Navigation pane, go to WLAN > AP Management > RF
Management.
The RF Configuration page is displayed as shown in Figure 109.
Figure 109. RF Configuration Page
2. Specify the fields described in Table 72 on page 206.