Allied Telesis AT-UWC Series - Manual (Page 291)

Chapter 5: Wireless LAN
291
3. Click the Pre-Auth History tab.
The Pre-Auth History page is displayed.
4. Observe the fields described in Table 121.
5. If you want to refresh the display, click Refresh.
Viewing
Triangulation
Information
You can view a list of access points that detected the rogue AP client.
Based on the information, you can determine the approximate location of
the rogue AP client. The Detected Client Triangulation page is only for
rogue AP clients.
To view a list of access points that detected the AP client, do the following:
1. From the Navigation pane, go to WLAN > Intrusion Detection >
Detected Clients.
The Detected Client Status page is displayed as shown in Figure 143
on page 284.
2. Click a MAC address from the AP client on the list.
Table 121. Pre-Auth History
Field Description
MAC Address Displays the MAC address of the AP client.
AP MAC
Address Displays the MAC address of the access point that
pre-authenticated the AP client.
Radio Interface
Number Displays the radio band of the wireless network
interface.
VAP MAC
Address Displays the MAC address of the VAP that the AP
client roamed.
SSID Displays the SSID that the VAP is serving.
Age Displays the time period since this Pre-Auth history
was recorded.
User Name Displays the user name of the AP client when the
client was 802.1x authenticated.
Pre-
Authentication
Status Displays the status of the pre-authentication. The
options are:
 Success
 Failure