Allied Telesis AT-UWC Series - Manual (Page 307)

Chapter 5: Wireless LAN
307
3. Click the following buttons as needed:
 Refresh — Refreshes the display on this page.
 Submit — Makes the changes effective and saves them to the
running configuration file.
Note
To save your changes to the startup configuration file, see “Save All
Applied Changes” on page 39.
Rogue AP Traps Enable or disable sending Rogue AP traps. When it
is enabled, the WLAN Controller sends a trap when
a rogue access point is detected.
WIDS Status
Traps Enable or disable sending WIDS Status traps.
When it is enabled, the WLAN Controller sends a
trap when the Wireless Intrusion Detection System
(WIDS) generates a message.
Wireless Status
Traps Enable or disable sending Wireless Status traps.
When it is enabled, the WLAN Controller sends a
trap when the WLAN Controller changes its
operational status.
In addition, the WLAN Controller sends a trap when
one of the following lists or database reaches the
maximum entry:
 Managed AP database
 AP Neighbor List
 Client Neighbor List
 AP Authentication Failure List
 RF Scan SP List
 Client Association Database
 Client Authentication Failure List
Table 129. Wireless SNMP Trap Configuration (Continued)
Field Description