Allied Telesis AT-UWC Series - Manual (Page 216)

AT-UWC WLAN Controller Web GUI User’s Guide
216
3. If you want to refresh the display, click Refresh.
Changing the
Debug Status
To change the debug status, do the following:
1. From the Navigation pane, go to WLAN > AP Management >
Advanced Settings.
The Managed AP Advanced Settings page is displayed as shown in
Figure 113 on page 215.
2. Click the value in the Debug column for the access point that you want
to change the status.
The Managed AP Advanced Debug page is displayed as shown in
Figure 114.
Figure 114. Managed AP Debug Page
3. Specifies the fields described in Table 78 on page 216.
Channel Displays the channel assigned to the access point.
Power Displays the RF power level of the access point.
Table 77. Managed AP Advanced Settings (Continued)
Field Description
Table 78. Managed AP Debug
Field Description
MAC address Displays the MAC address of the access point.
Location Displays the location information of the access point.
IP Address Displays the IP address of the access point.