Allied Telesis AT-UWC Series - Manual (Page 192)

AT-UWC WLAN Controller Web GUI User’s Guide
192
WLAN Controller
Operational
Status Displays the status of the WLAN Controller. The
options are:
 Enabled
 Disabled
 Enable Pending
 Disable Pending
WLAN Controller
Disable Reason Displays the reason why the WLAN Controller is
disabled. The options are:
 None - The WLAN Controller is enabled or
the reason is unknown.
 Admin - The WLAN Controller is disabled in
the Enable WLAN Controller field.
 No SSL Files - A Secure Sockets Layer
(SSL) file does not exist.
IP Address Displays the IP address of the WLAN Controller.
AP Validation
Require
Authentication
Passphrase Check the checkbox to require the WLAN
Controller to authenticate access points with the
pass phrase.
If the access point is in the Managed mode, you
can specify the pass phrase in the Valid AP list.
See “WLAN Basic Setup > Valid AP” on page 198.
If the access point is in the standalone mode, you
must specify the pass phrase on the access point.
RADIUS Server Configuration
RADIUS
Authentication
Server Name Specifies the name of the RADIUS authentication
server. This server is used for authentication when
no RADIUS authentication server is configured on
the WLAN Controller. To see configured RADIUS
servers, see “RADIUS Named Server Status” on
page 176.
RADIUS
Authentication
Server Status Displays whether the RADIUS authentication
server is configured on the WLAN Controller. To
add a RADIUS authentication server, see “RADIUS
Server Configuration” on page 175.
Table 66. Wireless Global Configuration (Continued)
Field Description