Allied Telesis AT-UWC Series - Manual (Page 276)

AT-UWC WLAN Controller Web GUI User’s Guide
276
Rogue/RF Scan
The access point scans the specified channels in the radio band, classifies
detected access points or AP clients as rogue if they fail to the tests, and
reports the results to the WLAN Controller.
From the Rogue/RF Scan page, you can view a list of access points that
the managed access points detected through RF scanning.
To view a list of AP clients that are detected, see “Detected Clients” on
page 284.
Viewing Access
Points Detected
by RF Scan
To view a list of access points detected by RF scan, do the following:
1. From the Navigation pane, go to WLAN > Intrusion Detection >
Rogue/RF Scan.
The Access Point RF Scan Status page is displayed as shown in
Figure 139.
Figure 139. Access Point RF Scan Status Page
2. Observe the fields described in Table 114.
Table 114. Access Point RF Scan Status
Field Description
MAC Address Displays the MAC address of the access point or
VAP.
OUI Displays the vendor, manufacturer, or organization
of the access point.