Allied Telesis AT-UWC Series - Manual (Page 335)

Chapter 5: Wireless LAN
335
No ACK Specifies whether sending ACK frames or not.
The options are:
 Enable - Requests AP clients not to send
ACK frames. The access point also does
not send ACK frames.
 Disable - No ACK frames to be sent.
Minimum Power (%) Specifies the minimum power in percentage for
the automatic power adjustment algorithm. See
“RF Management > Configuration” on page 205.
Mode Specifies the wireless standard that the access
point uses.
DTIM Period (#
beacons) Specifies how often the access point sends a
beacon frame with the Delivery traffic Indication
Message (DTIM) element. The default value is 10.
When the DTIM Period is set to 10, the access
point sends a beacon frame after sending 9
beacon frames without DTIM.
Beacon Interval
(msecs) Specifies the time interval in milliseconds
between beacon transmissions. The default value
is 100 milliseconds.
Automatic Channel Check the checkbox for the automatic channel
selection.
When Channel Plan Mode is selected to Fixed
Time or Interval, this filed must be checked. See
“RF Management > Configuration” on page 205.
Automatic Power Check the checkbox for the automatic RF power
adjustment.
Default Power (%) Specifies the default power level in percentage
against the maximum power.
APSD Mode Enables or disables Automatic Power Save
Delivery (APSD). APSD is the algorithm that
decrease the power consumption of VoIP phones
to extend the duration of call.
Frag Threshold (bytes) Specifies the packet size threshold for
fragmentation. The value must be an even
number between 256 and 2346. The access point
fragments a packet larger than this value before
transmitting.
Table 139. Access Point Profile Radio Configuration (Continued)
Field Description