Allied Telesis AT-UWC Series - Manual (Page 295)

Chapter 5: Wireless LAN
295
Ad Hoc Clients
From the Ad Hoc Client page, you can view AP clients connected to
wireless LAN via another AP client.
To view ad hoc clients, do the following:
1. From the Navigation pane, go to WLAN > Intrusion Detection > Ad Hoc
Clients.
The Ad Hoc Clients page is displayed.
2. Observe the fields described in Table 124.
3. Click the following buttons as needed:
 Delete All — Clears all the entries from the list. Clicking this button
does not disconnect the ad-hoc clients.
 Deny — Denies the ad-hoc client. When the client is on the Known
Table 124. Ad Hoc Clients
Field Description
MAC Address Displays the MAC address of the AP client.
AP MAC Address Displays the MAC address of the base access
point that detected the AP client.
Location Displays the location information of the AP client.
Radio Displays the radio band of the wireless network
interface of the access point.
Detection Mode Displays how the AP client was found as ad hoc.
The options are:
 Beacon
 Data Frame
When it is Beacon, the AP client is listed as an
access point in Access Point RF Scan Status
and AP Triangulation Status pages. See “Rogue/
RF Scan” on page 276.
When it is Data Frame, the AP client is listed in
the Known Client list. See “WLAN Advanced
Configuration > Known Client” on page 312.
Age Displays the time period since the AP client was
detected.