Yaskawa SGDB - Manual (Page 44)

BASIC USES OF Σ-SERIES PRODUCTS
2.3.1 Connecting to Peripheral Devices cont.
32
• Connector terminal block conversion unit (Type: JUSP-TA50P)
The terminal block allows connection to a host controller.
• Cable with 1CN connector and one end without con-
nector
1m (3.3ft) DE9406969-1
2m (6.6ft) DE9406969-2
3m (9.8ft) DE9406969-3
• 1CN connector kit (Type: DE9406970)
• Cable for PG
This cable is used to connect the encoder of servomotor to the SERVOPACK.
The following three types of cables are available according to encoder types.
For models SGMG, SGMS, SGMD
a) Cable with a single connector (without connector on encoder side)
Length
Cable type
Length
Incremental Absolute
3m (9.8ft) DE9406971-1 DE9406972-1
5m (16.4ft) DE9406971-2 DE9406972-2
10m (32.8ft) DE9406971-3 DE9406972-3
15m (49.2ft) DE9406971-4 DE9406972-4
20m (65.6ft) DE9406971-5 DE9406972-5
b) Cable with connectors on both side (straight plug on encoder side)
Length
Cable type
Length
Incremental Absolute
3m (9.8ft) DE9407234-1 DE9407236-1
5m (16.4ft) DE9407234-2 DE9407236-2
10m (32.8ft) DE9407234-3 DE9407236-3
15m (49.2ft) DE9407234-4 DE9407236-4
20m (65.6ft) DE9407234-5 DE9407236-5
2
1CN
0.5 meter cable with
1CN connector
1CN
1CN