Yaskawa SGDB User Manual

Page 209

USING THE DIGITAL OPERATOR

4.2.2 Operation Using the Digital Operator cont.

198

Operation Using the Digital Operator

Use the following procedure to operate the motor from the Digital Operator

For JUSP-OP02A-1

1. Press

DSPL

SET

to select the parameter setting

mode.

2. Select the parameter number Cn-00.

(Parameter Cn-00 is selected when the power
is turned ON.)

Press the

and

keys to select the

digit.

Press the

and

keys to change the value.

3. Press

DATA

ENTER

to display the current data for the

parameter Cn-00.

4. Press the

and

keys to change the data

to 00.
(This parameter is set to 00 when the power is
turned ON.)

5. Press

DSPL

SET

to set the Digital Operator in op-

eration mode. Operation is now possible under
Digital Operator control.

6. Press

JOG

SVON

to set the servo ON status (motor

power turned ON).

JUSP-OP02A-1

Setting Mode

Select Cn-00.

The selected digit

flashes.

Parameter

Number

Data

Set to 00-00.

keys to change the

value.

Press the

Display for operation mode from

Digital Operator

to change.

Servo ON

- motor ON

Servo OFF

- base block

Press