Yaskawa SGDB - Manual (Page 192)

4.1 Basic Operations
181
4.1.4 Basic Functions and Mode Selection
Digital Operator operation allows status display, parameter setting, operating reference, and
auto-tuning operations.
Basic Mode Selection
The four basic modes are listed below. Each time the mode key is pressed, the next mode in
the sequence is selected.
JUSP-OP02A-1
key to switch the mode.
JUSP-OP03A
key to switch the mode.
Press the Press the
Status Display
Mode → Section 4.1.5
Displays the SERVOPACK status as bit
data and codes.
Setting Mode → Section 4.1.6
Sets the parameters to select and set
all SERVOPACK functions.
Monitor Mode → Section 4.1.7
Displays the speed references to the SERVOPACK,
the actual speed, and internal status.
Alarm Trace-back
Mode → Section 4.2.1
Displays a log of previous alarms.
Special Modes
These modes are selected by setting
a value for parameter
Setting
Mode
Software-version check
mode → Section 4.2.8
Operation mode from Digital
Operator → Section 4.2.2
Reference offset automatic
adjustment mode
→ Section 4.2.4
Clear alarm trace-back
data → Section 4.2.6
Reference offset manual
adjustment mode
→ Section 4.2.5
Motor-type check mode
→ Section 4.2.7
Auto-tuning mode
→ Section 4.2.3
Current detection offset
manual adjustment mode
→ Section 4.2.9
4