Yaskawa SGDB - Manual (Page 36)

BASIC USES OF Σ-SERIES PRODUCTS
2.2.4 Installing the Servomotor
24
2.2.4 Installing the Servomotor
Servomotor SGMj type can be installed either horizontally or vertically. However, if the ser-
vomotor is installed incorrectly or in an inappropriate location, the service life will be short-
ened or unexpected problems will occur. To prevent this, always observe the installation
instructions described below.
When using the models with an oil seal, installing the motor with the output shaft up may
cause oil to enter the motor depending on the operating conditions. Check the operating
conditions.
Before installation :
Anticorrosive paint is coated on the edge of the motor shaft to prevent it from rusting dur-
ing storage. Clean off the anticorrosive paint thoroughly using a cloth before installing the
motor.
Anticorrosive paint is
coated here
NOTE Avoid getting thinner on other parts of the servomotor when cleaning the shaft.
Storage:
When the servomotor is to be stored with the power cable disconnected, store it in the
following temperature range:
Between −20°C and 60°C
2