Yaskawa SGDB - Manual (Page 193)

USING THE DIGITAL OPERATOR
4.1.5 Operation in Status Display Mode
182
4.1.5 Operation in Status Display Mode
The status display mode displays the SERVOPACK status as bit data and codes.
J Selecting Status Display Mode
The status display mode is displayed when the power is turned ON. If the status display
mode is not displayed, use the procedure shown in 4.1.4 Basic Functions and Mode
Selection to set the status display mode.
Keys to the status display are shown below.
For Speed Control
Code Bit Data
Speed Coincidence
Base Block
Control Power ON
Speed Reference Input
Torque Reference Input
Power Ready TGON
Code Status
Base block
Servo OFF (motor power OFF)
Run
Servo ON (motor power ON)
Forward Rotation Prohibited (P-OT)
1CN-42 (P-OT) OFF. See Cn-01 Bit 2 (page 57).
Reverse Rotation Prohibited (N-OT)
1CN-43 (N-OT) OFF. See Cn-01 Bit 3 (page 57).
Alarm Status
Displays the alarm number. See the table of alarms on page 196.
4