Yaskawa SGDB - Manual (Page 201)

USING THE DIGITAL OPERATOR
4.1.6 Operation in Parameter Setting Mode cont.
190
8. Press DATA
ENTER
once more to display the parameter
number again.
Refer to Appendix C List of Parameters.
For JUSP-OP03A
1. Press
MODE/SET
to select the parameter setting
mode.
2. Press the
UP
and
DOWN
keys to select the pa-
rameter number to set.
3. Press
MODE/SET
to display the current data for the
memory switch selected at step 2.
4. Press the
UP
and
DOWN
keys to select the bit
number to set.
5. Press
MODE/SET
to set the memory switch data
ON or OFF for the bit number.
6. Repeat steps 4 and 5 as often as required.
7. Press
DATA
to store the data.
8. Press
DATA
once more to display the parameter
number again.
Refer to Appendix C List of Parameter Settings
4
Parameter
Number
Memory
Switch Data
JUSP-OP03A
Setting
Mode
Parameter
Number
Memory
Switch Data
Bit
Number
to Set
Bit Number to Set
Bit
Number
The stored data
flashes.
Parameter
Number
Memory
Switch Data