HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 9)

TNC 425/TNC 415 B/TNC 407 1-8
1 Introduction
1.1 The TNC 425, TNC 415 B and TNC 407
PROGRAM RUN / FULL SEQUENCE, PROGRAM RUN / SINGLE BLOCK
A machining mode is
selected
Status display
Graphics
(or additional
status display,
or program
structure)
Soft-key row
MANUAL OPERATION and ELECTRONIC HANDWHEEL modes:
• Coordinates
• Selected axis
• ❊, if TNC is in
operation
• Status display,
e.g. feed rate F,
miscellaneous
function M,
Symbols for basic
rotation and/or tilted
working plane
A machining mode is
selected
Soft-key row
Additional
status display
Programming
mode
Text of the
selected
program
Programming
mode