beautypg.com

Mirror image (cycle 8), Yx z – HEIDENHAIN TNC 407 (280 580) User Manual User Manual

Page 257

background image

8-50

8

Cycles

TNC 407/TNC 415 B/TNC 425

8.5

Coordinate Transformation Cycles

Y

X

Z

Y

X

Z

Y

X

Z

MIRROR IMAGE (Cycle 8)

Application

This cycle makes it possible to machine the mirror
image of a contour in the machining plane.

Activation

The mirror image cycle is active immediately upon
definition. The mirrored axis is indicated in the
additional status display.

• If one axis is mirrored, the machining direction of

the tool is reversed (except in fixed cycles).

• If two axes are mirrored, the machining direction

remains the same.

The mirror image depends on the location of the
datum:

• The datum is located on the contour to be

mirrored: the part simply “flips over.”

• The datum is located outside the contour to be

mirrored: the part also “jumps” to another
location.

Input data

You enter the axes that you wish to mirror. The tool
axis cannot be mirrored.

Cancellation

The MIRROR IMAGE cycle is cancelled by
answering the dialog query with NO ENT.

Fig. 8.50:

MIRRORING a contour

Fig. 8.51:

Repeated mirroring, machining direction

Fig. 8.52:

Datum is located outside the contour to be mirrored