HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 7)

TNC 425/TNC 415 B/TNC 407 1-6
1 Introduction
1.1 The TNC 425, TNC 415 B and TNC 407
Screen layout
You can select the type of display on the TNC screen by pressing the
SPLIT SCREEN key and one of the soft keys listed below. Depending on
the active mode of operation, you can select:
Mode of operation Screen layout Soft key
MANUAL Display positions only
ELECTRONIC HANDWHEEL
Display positions in the left and
STATUS in the right screen window
POSITIONING WITH MANUAL DATA INPUT Display program blocks only
Display program blocks in the left and
STATUS in the right screens window
PROGRAM RUN / FULL SEQUENCE, Display program blocks only
PROGRAM RUN / SINGLE BLOCK,
TEST RUN
Display program blocks in the left and
program structure in the right screen window
Display program blocks in the left and
STATUS in the right screen window
Display program blocks in the left and
graphics in the right screen window
Display graphics only
PROGRAMMING AND EDITING Display program blocks only
Display program blocks in the left and
program structure in the right screen window
Display program blocks in the left and
programming graphics in the right screen window