beautypg.com

Ab d c – HEIDENHAIN TNC 407 (280 580) User Manual User Manual

Page 243

background image

8-36

8

Cycles

TNC 407/TNC 415 B/TNC 425

Fig. 8.40:

Cutter path for ROUGH-OUT:
A, B = pockets; C, D = islands

ROUGH-OUT (Cycle 22)

Process

• The control positions the tool over the cutter

infeed point

• The ALLOWANCE FOR SIDE is taken into

account.

• After reaching the first pecking depth, the tool

mills the contour in an outward direction at the
programmed feed rate Q12.

• First the island contours (C/D in Fig. 8.39) are

rough-milled until the pocket contour (A/B) is
approached.

• Then the pocket contour is rough-milled and the

tool is retracted to the CLEARANCE HEIGHT.

Input data

• PECKING DEPTH Q10:

Dimension by which the tool is plunged in each infeed
(negative sign for negative working direction)

• FEED RATE FOR PECKING Q11:

Traversing speed of the tool in mm/min during penetration

• FEED RATE FOR MILLING Q12:

Traversing speed of the tool in mm/min while milling

Required tool

The cycle requires a center-cut end mill (ISO 1641).

FLOOR FINISHING (Cycle 23)

Process

The function of cycle 23 FLOOR FINISHING is similar to cycle 22 ROUGH-
OUT. The tool approaches the machining plane in a vertically tangential
arc.

Input data

• FEED RATE FOR PECKING Q11:

Traversing speed of the tool during penetration

• FEED RATE FOR MILLING Q12:

Traversing speed in the machining plane

8.4

SL Cycles (Group II)

A

B

D

C