beautypg.com

HEIDENHAIN TNC 407 (280 580) User Manual User Manual

Page 53

background image

TNC 425/TNC 415 B/TNC 407

3-5

3

Test Run and Program Run

3.2

Program Run

Interrupting machining

There are various ways to interrupt a program run:

• Programmed interruptions
• Machine STOP key
• Switching to PROGRAM RUN / SINGLE BLOCK

If the TNC registers an error during program run, it automatically interrupts
machining.

Programmed interruptions

Interruptions can be programmed directly in the part program. The part
program is interrupted at a block containing one of the following entries:

• STOP
• Miscellaneous function M0, M02 or M30
• Miscellaneous function M06, if the machine tool builder has assigned

it a stop function

To interrupt or abort machining immediately:

The block which the TNC is currently executing is not completed.

Interrupt machining.

The ❊ sign in the status display blinks.

The part program can be aborted with the INTERNAL STOP function.

Abort machining.

The ❊ sign in the status display goes out.

To interrupt machining at the end of the current block:

You can interrupt the program run at the end of the current block by
switching to the PROGRAM RUN / SINGLE BLOCK mode.

Select PROGRAM RUN / SINGLE BLOCK.