HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 348)

12-4
12 Tables and Overviews
TNC 425/TNC 415 B/TNC 407
12.1 General User Parameters
Type of touch probe
MP6200 Triggering touch probe: 0
Measuring touch probe: 1
Type of transmission
MP6010 Cable transmission: 0
Infrared transmission: 1
Probe feed rate for TS 120/TS 511
MP6120 80 to 3000 [mm/min]
Maximum traverse to first probe point
MP6130 0 to 99 999.9999 [mm]
Safety clearance to probe point during automatic measurement
MP6140 0 to 99 999.9999 [mm]
Rapid traverse for probing with TS 120/TS 511
MP6150 1 to 300 000 [mm/min]
Measure center misalignment of stylus for calibration of TT 120/TS 511
MP6160 No 180° rotation of 3D touch probe during calibration: 0
M function for 180° rotation of touch probe during calibration: 1 to 88
Lubrication of touch probe axis during digitizing with TS 120
MP6220 Traverse in the touch probe axis at end of line: 0 to 99 999.9999 [mm]
Lubrication of touch probe axis during digitizing with TS 120
MP6221 Lubricate after: 0 to 65 535 [sec]
3D touch probes and digitizing