beautypg.com

Enter program stop in a program, Stop, 8 entering miscellaneous functions and stop – HEIDENHAIN TNC 407 (280 580) User Manual User Manual

Page 89

background image

TNC 425/TNC 415 B/TNC 407

4-30

4

Programming

4.8 Entering Miscellaneous Functions and STOP

Some M functions are not effective on certain machines. The machine tool builder may also
add some of his own M functions. See your machine tool manual.

The M functions (M for miscellaneous) affect:

• Program run
• Machine function
• Tool behavior

On the inside back cover of this manual you will find a list of M functions
that are predetermined for the TNC. The list indicates whether an
M function begins at the start, or at the end of the block in which it is
programmed.

Answer the following requests in a positioning block:

MISCELLANEOUS FUNCTION M?

Enter the miscellaneous function, for example M3 (spindle ON,
clockwise rotation).

To enter an M function in a STOP block:

MISCELLANEOUS FUNCTION M?

Enter the miscellaneous function, for example M5 (spindle STOP).

Resulting NC block: STOP M5

If the M function was programmed in a STOP block, program run will be
interrupted at that block.

Some M functions are not effective on certain machines. The machine tool builder may also
add some of his own M functions.

A program run or test run is interrupted when it reaches a block contain-
ing the STOP function.

An M function can be programmed in a STOP block.

If you wish to interrupt the program run or program test for a certain
duration, use the cycle 9: DWELL TIME (see page 8-56).

To enter a STOP function:

Press the STOP key.

MISCELLANEOUS FUNCTION M ?

Enter an M function, if desired, for example M6 (tool change).

Resulting NC block: STOP M6

.
.

STOP

6

e.g.

ENT

ENT

3

e.g.

.
.

ENT

e.g.

5