Programming and editing, Skip dialog questions, delete words, Confirm entry and resume dialog – HEIDENHAIN TNC 407 (280 580) User Manual User Manual
Page 61: End block, Abort dialog; delete program sections, 4programming, 1 creating part programs

TNC 425/TNC 415 B/TNC 407
4-2
4
Programming
Fig. 4 1:
Program blocks contain words of specific information
4
Programming
In the PROGRAMMING AND EDITING mode of
operation (see page 1-32) you can
• create files,
• add to files, and
• edit files.
This chapter describes the basic functions and input that do not yet cause
machine axis movement. The entry of geometry for workpiece machining
is described in the next chapter.
4.1 Creating Part Programs
Layout of a program
A part program consists of individual program
blocks. The TNC numbers the blocks in ascending
sequence. Program blocks contain units of informa-
tion called
words.
Plain language dialog
You initiate a dialog for conversational programming by pressing a function
key (see inside front cover). The TNC then asks you for all the information
necessary to program the desired function. After you have answered all
the questions, the TNC automatically ends the dialog.
If only a few of the words in a block need be programmed, you can cut off
the dialog and end the block before the dialog is finished.
Function
Key
• Continue the dialog
• Ignore the dialog question
• End the dialog immediately
• Abort the dialog and erase the block
DEL
Block:
10
L
X+10 Y+5
R0
F100 M3
Path
function
Block
Words
number
ENT
END
NO
ENT