HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 149)

TNC 425/TNC 415 B/TNC 407 5–50
5 Programming Tool Movements
5.6 Contours – FK Free Contour Programming
Auxiliary points
• Auxiliary points on a straight line or on the extension of a straight line
Known data Dialog Soft key
X coordinate of an auxiliary point 1 AUXILIARY POINT 1 X-COORDINATE ?
Y coordinate of an auxiliary point 1 AUXILIARY POINT 1 Y-COORDINATE ?
X coordinate of an auxiliary point 2 AUXILIARY POINT 2 X-COORDINATE ?
Y coordinate of an auxiliary point 2 AUXILIARY POINT 2 Y-COORDINATE ?
• Auxiliary point at a distance D from a straight line
Known data Dialog Soft key
X coordinate of the auxiliary point DIST AUXIL POINT PD X-COORDINATE
Y coordinate of the auxiliary point DIST AUXIL POINT PD Y-COORDINATE
Distance auxiliary point/straight line DISTANCE FROM AUXILIARY POINT ?