HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 29)

TNC 425/TNC 415 B/TNC 407 1-28
1 Introduction
1.4 Graphics and Status Displays
Tool information
T: Tool name and number
RT: Name and number of a replacement tool
Tool axis
Display of the programmed tool and the (next)
replacement tool
Tool life, maximum tool life and maximum tool life
for TOOL CALL
Oversizes (delta values)
Tool length and radii
Main program name
Coordinates of the datum shift
Angle of basic rotation
Mirrored axis
Scaling datum
Scaling factor(s)
Coordinate transformations
Number of the tool to be measured
Tool measurement
Measured MIN and MAX values of the
single cutting edges and the result of
measuring the rotating tool
When working with the TT 110: Cutting edge
number with the corresponding measured value. If
the measured value is followed by an asterisk, the
allowable tolerance defined in the tool table was
exceeded.
Display whether the tool radius or the tool length is
being measured