HEIDENHAIN TNC 407 (280 580) User Manual User Manual
Page 281

TNC 425/TNC 415 B/TNC 407
9-14
9
3D Touch Probes
Fig. 9.14:
Probing an inside cylindrical
surface to find the center
Touch Probe Cycles in the MANUAL and ELECTRONIC HANDWHEEL Operating Modes
Y
X
XÐ
X+
Y+
YÐ
Circle center as datum
With this function you can set the datum at the center of bore holes,
circular pockets, cylinders, journals, circular islands etc.
Select the probe function with the soft key PROBING CC.
Inside circle
The TNC automatically probes the inside wall in all four coordinate axis
directions.
For incomplete circles (circular arcs) you can choose the appropriate
probing directions.
4 x
I
4 x
I
END
Move the touch probe to a position approximately in the center of the circle.
X + X Y + Y
The probe touches 4 points on the inside of the circle.
To compensate any ball-tip center offset, press the soft key to rotate
the touch probe by 180 degrees, and probe the 4 points on the inside
cylinder surface again. (This operation is possible only on machines
with spindle orientation, defined in MP6160).
No probing from opposite spindle orientations.