HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 28)

TNC 425/TNC 415 B/TNC 407 1-27
1 Introduction
1.4 Graphics and Status Displays
Name of main program
Active programs
Machining time
Circle center CC (pole)
Type of position display
Tilt angle of the working plane
Coordinates of the axes
Display of a basic rotation
Dwell time counter
Cycle definition
General program information
Positions and coordinates
Additional status display Soft key
General program information
Positions and coordinates
Tool information
Coordinate transformations
Tool measurement