HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 357)

12-13
12 Tables and Overviews
TNC 425/TNC 415 B/TNC 407
12.1 General User Parameters
Electronic handwheels
Handwheel type
MP7640 Machine without handwheel: 0
HR 330 with additional keys– the keys for traverse direction and rapid traverse on the
handwheel are evaluated by the NC:
1
HR 130 without additional keys: 2
HR 330 with additional keys– the keys for traverse direction and rapid traverse on the
handwheel are evaluated by the PLC:
3
HR 332 with 12 additional keys: 4
Multi-axis handwheel with additional keys: 5
Setting the interpolation factor
MP7641 Interpolation factor is entered from the keyboard: 0
Interpolation factor is set by the PLC: 1
Functions set by the machine tool builder for the handwheel
MP 7645.0 0 to 255
MP 7645.1 0 to 255
MP 7645.2 0 to 255
MP 7645.3 0 to 255
MP 7645.4 0 to 255
MP 7645.5 0 to 255
MP 7645.6 0 to 255
MP 7645.7 0 to 255