HEIDENHAIN TNC 407 (280 580) User Manual User Manual
Page 374
12-30
12
Tables and Overviews
TNC 425/TNC 415 B/TNC 407
ROTATION NOT PERMITTED
Reset all coordinate transformations before digitizing.
SCALING FACTOR NOT PERMITTED
Reset all coordinate transformations before digitizing.
START POSITION INCORRECT
Program the starting point coordinates for the CONTOUR LINES cycle
within the RANGE.
STYLUS ALREADY IN CONTACT
Pre-position the touch probe so that the stylus cannot be deflected
outside the RANGE.
TIME LIMIT EXCEEDED
Enter a TIME LIMIT that is appropriate to the 3D surface to be scanned
(CONTOUR LINES cycle).
TOO MANY POINTS
You can define up to 893 points in the PNT file; scan the digitizing range
again and, if necessary, program a larger probe point interval.
TOUCH POINT INACCESSIBLE
• The stylus must not be deflected before it reaches the RANGE.
• The stylus must be deflected somewhere within the RANGE.
WRONG AXIS PROGRAMMED
• Enter calibrated touch probe axis in the RANGE cycle.
• Enter the correct rotary axis in the RANGE cycle.
• Do not program the same axes twice in the RANGE cycle.