HEIDENHAIN TNC 407 (280 580) User Manual - Manual (Page 173)

TNC 425/TNC 415 B/TNC 407 5-74
5 Programming Tool Movements
5.9 Positioning with Manual Data Input (MDI)
L
END
Example application
Correcting workpiece misalignment on machines with rotary tables
Make a basic rotation with the 3D touch probe; write down the
ROTATION ANGLE and remove the basic rotation again.
• Change the operating mode
POSITIONING MANUAL DATA INPUT
Open the system file $MDI.
• Program the rotation
COORDINATES ?
• Select the rotary axis.
• Enter the ROTATION ANGLE that you previously wrote down.
• Enter the FEED RATE.
Close the block.
Start the program: the rotary axis corrects the misalignment.
START