HEIDENHAIN TNC 407 (280 580) User Manual User Manual
Page 371
![background image](https://www.manualsdir.com/files/815347/content/doc371.png)
12-27
12
Tables and Overviews
TNC 425/TNC 415 B/TNC 407
PGM-SECTION CANNOT BE SHOWN
• Enter a smaller tool radius.
• 4D and 5D movements cannot be graphically simulated.
• Enter a tool axis for simulation that is the same as the axis in the
BLK FORM.
PLANE WRONGLY DEFINED
• Do not change the tool axis while a basic rotation is active.
• Define the main axes for circular arcs correctly.
• Define both main axes for CC.
PROBE SYSTEM NOT READY
• Orient the transmitting/receiving window of the TS 511 to the receiving
unit.
• Check whether the touch probe is ready for operation.
PROGRAM-START UNDEFINED
• Begin the program at a TOOL DEF block.
• Do not resume an interrupted program at a block with a tangential arc
or if a previously defined pole is needed.
RADIUS COMPENSATION UNDEFINED
Enter a radius compensation RR or RL in the first subprogram to cycle 14
CONTOUR GEOM.
ROUNDING OFF NOT PERMITTED
Enter tangentially connecting circles and rounding circles correctly.
ROUNDING RADIUS TOO LARGE
Rounding arcs must fit between contour elements.
SCALING FACTOR NOT PERMITTED
Enter identical scaling factors for coordinate axes in the plane of the circle.